返回首页
当前位置: 主页 > 精通Office > Ubuntu教程 >

Cisco MP(multilink ppp)的配置图解教程

时间:2012-02-25 22:23来源:知行网www.zhixing123.cn 编辑:麦田守望者

两种配置方法。一种是通过配置虚拟模板接口(Virtual-Template,VT)来实现MP,另一种是利用MP-Group接口实现MP。

方法一mp group:

interface Multilink1
ip address 192.168.0.1 255.255.255.0
ppp multilink
multilink-group 1
!
interface Serial0/0
no ip address
encapsulation ppp
serial restart-delay 0
ppp multilink
multilink-group 1
!
interface Serial0/1
no ip address
encapsulation ppp
serial restart-delay 0
ppp multilink
multilink-group 1
!

注意事项:

Cisco MP(multilink ppp)的配置图解教程
Cisco MP(multilink ppp)的配置图解教程
 

1.输入ppp multilink group 1会自动转换为
ppp multilink
multilink-group 1

2.保障接口 no shutdown

参考资料:

http://dreamearth.blog.51cto.com/616542/149360

—————————————-

方法二:使用virtual-template:

multilink virtual-template 1
!
interface Virtual-Template1
ip address 192.168.0.1 255.255.255.0
ppp multilink
!
interface Serial0/0
encapsulation ppp
ppp multilink
!
interface Serial0/1
encapsulation ppp
ppp multilink

实验验证:

Router#sh ip int bri
Interface IP-Address OK? Method Status Protocol
Serial0/0 unassigned YES unset up up
Serial0/1 unassigned YES unset up up
Virtual-Access1 192.168.0.1 YES TFTP up up
Virtual-Template1 192.168.0.1 YES manual down down
Router#sh int virtual-access 1
Virtual-Access1 is up, line protocol is up
Hardware is Virtual Access interface
Internet address is 192.168.0.1/24
MTU 1500 bytes, BW 3088 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set

切断一条链路后

Router#sh ip int bri
Interface IP-Address OK? Method Status Protocol
Serial0/0 unassigned YES unset up down
Serial0/1 unassigned YES unset up up
Virtual-Access1 192.168.0.1 YES TFTP up up
Virtual-Template1 192.168.0.1 YES manual down down

------分隔线----------------------------
标签(Tag):Linux Android 操作系统 Unix
------分隔线----------------------------
推荐内容
猜你感兴趣